D-Link DGS-1510 Series - Page 661

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
658
Switch# configure terminal
Switch(config)# interface eth1/0/1
Switch(config-if)# voice vlan enable
Switch(config-if)#
76-4 voice vlan mac-address
This command is used to add the user-defined voice device OUI. Use the no form of this command to
delete the user-defined voice device OUI.
voice vlan mac-address MAC-ADDRESS MASK [description TEXT]
no voice vlan mac-address MAC-ADDRESS MASK
Parameters
MAC-ADDRES
Specifies the OUI MAC address.
MASK
Specifies the OUI MAC address matching bitmask.
description TEXT
(Optional) Specifies the description for the user defined OUI with a
maximum of 32 characters.
Default
The default OUI is listed in the following table:
OUI
Vendor
00:E0:BB
3COM
00:03:6B
Cisco
00:E0:75
Veritel
00:D0:1E
Pingtel
00:01:E3
Siemens
00:60:B9
NEC/Philips
00:0F:E2
Huawei-3COM
00:09:6E
Avaya
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to add a user-defined OUI for the voice VLAN. The OUI for the voice VLAN is used
to identify the voice traffic by using the voice VLAN function. If the source MAC addresses of the
received packet matches any of the OUI patterns, the received packet is determined as a voice
packet.
The user-defined OUI cannot be the same as the default OUI. The default OUI cannot be deleted.
Example
This example shows how to add a user-defined OUI for voice devices.