D-Link DGS-1510 Series - Page 670

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
667
Switch# configure terminal
Switch(config)# web-auth virtual-ip ipv6 2000::2
Switch(config)# web-auth virtual-ip url www.website6.co
Switch(config)#
77-6 snmp-server enable traps web-auth
This command is used to enable sending SNMP notifications for Web-Authentication. Use the no form
of this command to disable sending SNMP notifications.
snmp-server enable traps web-auth
no snmp-server enable traps web-auth
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to enable or disable sending SNMP notifications for Web-Authentication.
Example
This example shows how to enable sending SNMP notifications for Web-Authentication
Switch# configure terminal
Switch(config)# snmp-server enable traps web-auth
Switch(config)#