D-Link DGS-1510 Series - Page 681

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
678
interface-id: Interface name
Interface
Log Description
Severity
Event description: When port is down
Log Message: Port <port-type>< interface-id> link down
Parameters description:
port-type: port type
interface-id: Interface name
Informational
Event description: When port is up
Log Message: Port <port-type>< interface-id> link up, <link-speed>
Parameters description:
port-type: port type
interface-id: Interface name
link-speed: port link speed.
Informational
JWAC
Log Description
Severity
Event description: when a host has passed the authentication.
Log Message: JWAC host login success (Username: <string>, IP: <ipaddr |
ipv6address>, MAC: <mac-address>, <interface-id>, VID: <vlan-id>).
Parameters description:
Username: The host username.
IP: The host IP address
mac-address: The host MAC addresses.
interface-id: The interface on which the host is authenticated.
vlan-id: The VLAN ID on which the host exists.
Informational
Event description: When a host fail to pass the authentication.
Log Message: JWAC host login fail (Username: <string>, IP: <ipaddr |
ipv6address>, MAC: <mac-address>, <interface-id>, VID: <vlan-id>)
Parameters description:
Username: The host username.
IP: The host IP address
mac-address: The host MAC addresses..
interface-id: The interface on which the host is authenticated.
vlan-id: The VLAN ID on which the host exists.
Critical
Event description: when the authorized user number on the whole device has
reached the maximum user limit.
Log Message: JWAC enters stop learning state.
Warning
Event description: when the authorized user number on the whole device is
below the maximum user limit in a time interval.
Log Message: JWAC recovers from stop learning state.
Warning
Event description: when the ACL hardware resource is exhausted..
Log Message: JWAC cannot work correctly because ACL rule resource is not
available.
Alert
LACP