D-Link DGS-1510 Series - Page 74

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
71
This example shows how to configure the HTTP TCP port number to 8080.
Switch# configure terminal
Switch(config)# ip http service-port 8080
Switch(config)#
5-8 ip http timeout-policy idle
This command is used to set idle timeout of a http server connection in seconds. Use the no form of
this command to set the idle timeout to default value.
ip http timeout-policy idle INT
no ip http timeout-policy idle
Parameters
INT
Specifies the idle timeout value. This value is between 60 and
36000.
Default
By default, this value is 180 seconds.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is use to configure the idle timeout value of a http server connection in seconds.
Example
This example shows how to configure the idle timeout value to 100 seconds .
Switch#configure terminal
Switch(config)#ip http timeout-policy idle 100
Switch(config)#
5-9 ip telnet server
This command is used to enable a Telnet server. Use the no form of this command to disable the
Telnet server function
ip telnet server
no ip telnet server
Parameters
None.
Default
By default, this option is enabled.
Command Mode