D-Link DGS-1510 Series - Page 79

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
76
Switch#show ip http server
ip http server state : enable
Switch#
5-16 show ip http secure-server
This command is used to obtain information about the SSL status. Use this command in EXEC mode
or any configuration mode.
show ip http secure-server
Parameters
None.
Default
By default, the state is disabled.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display information about the SSL status.
Example
This example shows how to display information about the SSL status.
Switch#show ip http secure-server
ip http secure-server state : disable
Switch#
5-17 show users
This command is used to display information about the active lines on the Switch.
show users
Parameters
None.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.