D-Link DGS-3100 SERIES Hardware Installation Guide

DGS-3100 Series Gigabit Stackable Managed Switch Hardware Installation Guide
8
2
UNPACKING AND SETUP
This chapter contains information for unpacking and setting up the DGS-3100 Series. Before beginning the Installation and
Configuration process, see Safety Instructions.
This section contains the following topics:
•
Unpacking the Device
•
Safety Instructions
•
General Precautions for Rack-Mountable Products
•
Protecting Against Electrostatic Discharge
•
Installing the Device
•
Powering on the Device
•
Using the External Redundant Power
•
Web-Based Network Management

D-Link DGS-3100 SERIES Specifications

General

Type	Managed
Layer	Layer 2+
Ports	10/100/1000BASE-T
SFP Ports	2 or 4 (depends on the model)
Additional SFP Ports	No
VLANs	Yes
Stacking	Yes, Physical Stacking
QoS	Yes
Jumbo Frame Support	Up to 9K bytes
Management	Web-based
Operating Temperature	0°C to 40°C
Humidity	10% to 90% non-condensing
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.3x, IEEE 802.1D, IEEE 802.1w, IEEE 802.1s, IEEE 802.1Q, IEEE 802.1p
Model	DGS-3100 SERIES
Storage Temperature	-40°C to 70°C