D-Link DGS-3100 SERIES Hardware Installation Guide

DGS-3100 Series Gigabit Stackable Managed Switch Hardware Installation Guide
Troubleshooting Device Connections
Ensure the terminal or PC connection is configured to match the below settings.
If problems occur while connecting to the PC, ensure the emulation is set to VT-100. To set the emulation, select File >
Properties > Settings tab in the HyperTerminal window. The Emulation options are displayed in the HyperTerminal
Window:
Figure 3-7. Settings Tab in HyperTerminal Window
If the Emulation options are not displayed in the HyperTerminal window, reboot the device by disconnecting the power
supply.
27

D-Link DGS-3100 SERIES Specifications

General

Type	Managed
Layer	Layer 2+
Ports	10/100/1000BASE-T
SFP Ports	2 or 4 (depends on the model)
Additional SFP Ports	No
VLANs	Yes
Stacking	Yes, Physical Stacking
QoS	Yes
Jumbo Frame Support	Up to 9K bytes
Management	Web-based
Operating Temperature	0°C to 40°C
Humidity	10% to 90% non-condensing
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.3x, IEEE 802.1D, IEEE 802.1w, IEEE 802.1s, IEEE 802.1Q, IEEE 802.1p
Model	DGS-3100 SERIES
Storage Temperature	-40°C to 70°C