D-Link DGS-3100 SERIES Hardware Installation Guide

DGS-3100 Series Gigabit Stackable Managed Switch Hardware Installation Guide
31
Initial Configuration
Initial configuration, which starts after the device has booted successfully, includes static IP address and subnet mask
configuration, and setting user name and privilege level to allow remote management. If the device is to be managed from
an SNMP-based management station, SNMP community strings must also be configured. The following configurations are
completed:
•
Device Configuration
•
Static IP Address and Subnet Mask
•
User Name
•
Defining SNMP Community Strings
•
SNMP Trap Management
Device Configuration
CPLD revision: 0.00
Slot 1 - DGS-3100-48P ST HW Rev. 0.0
------------------------------------
-- Unit Standalone --
------------------------------------
Running eeprom code for 98DX269 Dev 0. Please wait...
Running eeprom code for 98DX269 Dev 1. Please wait...
Tapi Version: v1.3.3.1
Core Version: v1.3.3.1
01-Jan-2000 01:04:01 %INIT-I-InitCompleted: Initialization task is completed
01-Jan-2000 01:04:01 %SNMP-I-CDBITEMSNUM: Number of running configuration items
loaded:
0
01-Jan-2000 01:04:01 %SNMP-I-CDBITEMSNUM: Number of startup configuration items
loaded:
0
01-Jan-2000 01:04:02 %Box-A-FAN-STAT-CHNG: FAN# 1 status is - not operational.
01-Jan-2000 01:04:02 %Entity-I-SEND-ENT-CONF-CHANGE-TRAP: entity configuration
change trap.
01-Jan-2000 01:04:02 %Box-W-PS-STAT-CHNG: PS# 1 status is - not operational.
Static IP Address and Subnet Mask
IP Interfaces can be configured on each VLAN configured the device. After entering the configuration command, check that
the IP interface is configured according to the predefined parameters.
The commands to configure the device are port specific.
To manage the switch from a remote network, a static route must be created as an IP address to where packets are sent when
no entries are found in the device tables. The configured IP address must belong to the same subnet of the device IP
interface.
To configure a static route, enter the command at the system prompt as shown in the following example; where 0.0.0.0
defines the destination outside the subnet, and 100.1.1.3 is the static route (default gateway) to which packets with other
subnet destinations are sent:

D-Link DGS-3100 SERIES Specifications

General

Type	Managed
Layer	Layer 2+
Ports	10/100/1000BASE-T
SFP Ports	2 or 4 (depends on the model)
Additional SFP Ports	No
VLANs	Yes
Stacking	Yes, Physical Stacking
QoS	Yes
Jumbo Frame Support	Up to 9K bytes
Management	Web-based
Operating Temperature	0°C to 40°C
Humidity	10% to 90% non-condensing
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.3x, IEEE 802.1D, IEEE 802.1w, IEEE 802.1s, IEEE 802.1Q, IEEE 802.1p
Model	DGS-3100 SERIES
Storage Temperature	-40°C to 70°C