DGS-3100 Series Gigabit Stackable Managed Switch Hardware Installation Guide
Web-Based Network Management
Introduction
The DGS-3100 Series offers an embedded Web-based (HTML) interface allowing users to manage the device from
anywhere on the network through a standard browser, such as Netscape Navigator/Communicator, Microsoft Internet
Explorer, or Mozilla Firefox. The Web browser acts as a universal access tool and can communicate directly with the
Switch using the HTTP protocol. The browser window may vary with the screen shots (pictures) in this manual.
The Web-based management module and the Console program (and Telnet) are different ways to access the same internal
switching software and configure it. Thus, all settings encountered in Web-based management are the same as those found
in the console program.
NOTE: This Web-based Management module does not accept Chinese language input (or other
languages requiring 2 bytes per character).
NOTE: The Web browser needs to be upgraded to the latest Java version (JavaTM Plug-in: version
1.5.0 or later)
Login to Web Manager
To begin managing the device, simply run the browser installed on the management station and point it to the IP address
defined for the device., for example; http://123.123.123.123, where the numbers 123 represent the IP address of the switch.
Please note that the proxy for session connection should be turned off.
NOTE: The Factory default IP address for the Switch is 10.90.90.90
This section contains information on starting the D-Link Embedded Web Interface. To access the D-Link user interface:
Open an Internet browser. Ensure that pop-up blockers are disabled. If pop-up blockers are enabled, edit, add, and device
information messages may not open.
Enter the device IP address in the address bar and press Enter.
16
To Next Page
Loading...
Need help?
General
