DGS-3100 Series Gigabit Stackable Managed Switch Hardware Installation Guide
33
All parameters are manageable from any SNMP management platform, except the SNMP management station IP address
and community (community name and access rights). The SNMP management access to the switch is disabled if no
community strings exist. The device switch is delivered with no community strings configured.
The following syntax displays the default device configuration:
DGS3100# create snmp community Tony read_write view Default
DGS3100# sh snmp community
Community-Name View name Access Right
-------------------- ------------------ -------------- ------------
Access Default read write
Tony Default read write
Total Entries 2
DGS3100# create snmp host 100.1.1.3 v1 Tony
DGS3100# show snmp host
SNMP Host Table
Host IP Address SNMP Version Community Name / SNMPv3
-------------------- ---------------------- ------------------------- ------------
100.1.1.3 V1 Tony
Total Entries: 1
SNMP Trap Management
Traps are messages which alert network personnel of events that occur on the switch. The events can be as serious as a
reboot, or less serious like a port status changes. The switch generates traps and sends them to the trap recipient.
This completes the initial configuration of the device from a local terminal. The configured parameters enable further device
configuration from any remote location.
To Next Page
Loading...
Need help?
General
