D-Link DGS-3100 SERIES Hardware Installation Guide

DGS-3100 Series Gigabit Stackable Managed Switch Hardware Installation Guide
39
Restore Default Button
Reboot Device
This section contains instructions for rebooting device. A Restore Default Button that is used to reboot device after press the
button.
DGS3100#
To perform reset to factory defaults please do not release the button during 5
seconds
**************************************************
***************** SYSTEM RESET *****************
**************************************************
Restore Default Settings
This section contains instructions for restoring default settings. A Restore Default Button that is used to restore default
settings. To restore defaults settings the button must be held down for five seconds. It will delete startup configuration
automatically.
DGS3100#
To perform reset to factory defaults please do not release the button during 5
seconds
Deleting auto update backup file...OK
Deleting auto update instruction file...OK
Deleting startup configuration file... Done.
Please make sure that your terminal is set to the default baud rate - 9600 bps.
**************************************************
***************** SYSTEM RESET *****************
**************************************************

D-Link DGS-3100 SERIES Specifications

General

Type	Managed
Layer	Layer 2+
Ports	10/100/1000BASE-T
SFP Ports	2 or 4 (depends on the model)
Additional SFP Ports	No
VLANs	Yes
Stacking	Yes, Physical Stacking
QoS	Yes
Jumbo Frame Support	Up to 9K bytes
Management	Web-based
Operating Temperature	0°C to 40°C
Humidity	10% to 90% non-condensing
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.3x, IEEE 802.1D, IEEE 802.1w, IEEE 802.1s, IEEE 802.1Q, IEEE 802.1p
Model	DGS-3100 SERIES
Storage Temperature	-40°C to 70°C