D-Link DGS-3100 SERIES Hardware Installation Guide

DGS-3100 Series Gigabit Stackable Managed Switch Hardware Installation Guide
25
9. Enter the user name and password at the prompt.
10. Enter the key at the user name and password prompts. The device does not have default user name and password.
User names and passwords are created by the administrator doing the initial device configuration. If previous user
accounts exist, log in and continue to configure the device.
11. Begin the initial device configuration. Many commands require administrator-level access privileges.
For more information on assigning administration access levels, see "Security Management and Password Configuration".
For the complete CLI list, see the DGS-3100 Series Managed Switch CLI Manual.
To exit the configuration session:
• Enter logout, or close the Emulator program.
Once connected to the console, the screen below appears on the console screen. It is here users enter commands to perform
all the available management functions. The switch prompts the user to enter a username and password. Upon initial
connection, there is no username or password, and therefore just press Enter twice to access the command line interface.
User Name
Figure 3-5. Initial Screen after First Connection

D-Link DGS-3100 SERIES Specifications

General

Type	Managed
Layer	Layer 2+
Ports	10/100/1000BASE-T
SFP Ports	2 or 4 (depends on the model)
Additional SFP Ports	No
VLANs	Yes
Stacking	Yes, Physical Stacking
QoS	Yes
Jumbo Frame Support	Up to 9K bytes
Management	Web-based
Operating Temperature	0°C to 40°C
Humidity	10% to 90% non-condensing
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.3x, IEEE 802.1D, IEEE 802.1w, IEEE 802.1s, IEEE 802.1Q, IEEE 802.1p
Model	DGS-3100 SERIES
Storage Temperature	-40°C to 70°C