119
Step 23 Follow these instructions to configure your other DI-808HV using the exact
same settings for the IKE Proposal and the IPSec Proposal. Also make sure that
Step 4 is configured to reflect the LAN settings for what is now the Local DI-808HV
and that Steps 5 & 6 are configured to reflect the Subnet and WAN IP of what is now
the remote DI-808HV
Step 24 To establish the connection, open a command prompt and ping an IP
address of a computer on the remote LAN. Once you receive replies the tunnel has
been established.
I have two DI-808HV Routers, how can I set them up to work with
each other?(continued)
Frequently Asked Questions (continued)
You need to first configure your DI-808HV router.
How can I set up my DI-808HV to work with a DI-804V or DI-804HV Router?
Step 1 Log into the Web-based
configuration of the router by typing in
the IP address of the router (default:
192.168.0.1) in your web browser. By
default the username is “admin” and there
is no password.
Step 2 Click the VPN button on the left
column, select the checkbox to Enable
the VPN, and then in the box next to
Max. number of tunnels, enter the
maximum numbers of VPN tunnels that
you would like to have connected.
To Next Page
Loading...
Need help?
General
