D-Link DI-808HV - Resetting to Factory Defaults; Factory Reset Procedure

98
After you have tried other methods for troubleshooting your network, you
may choose to Reset the DI-808HV to the factory default settings.
To hard-reset the D-Link DI-808HV to the Factory Default Settings, please do
the following:
Resetting the DI-808HV to the
Factory Default Settings


Use a paper clip to press the Reset button and
power on.
Locate the Reset button on the back of the DI-808HV.
 After you have completed the above steps, the DI-808HV
will be reset to the factory default settings.

Hold for about 5 seconds (do not hold for too long)
and then release. (Or, release when M1 and M2
flash at the same time.)