51
Using the Configuration Menu
Advanced > Filter > IP Filter
IP Filter
Use IP Filters to deny LAN IP addresses access to the internet
Protocol
IP Address
Enter in the IP address range of the computers that you want the policy to apply to. If it
is only a single computer that you want the policy applied to, then enter the IP address of
that computer in the Start Source IP and leave the End Source IP blank.
Use IP (Internet Protocol)
filters to allow or deny
computers access to the
Internet based on their IP
address.
Port Range
Enter in the port range of the TCP/UDP ports that you want the policy to apply to. If it is
only a single port that you want the policy applied to, then enter the port number in the
Start Port field and leave the End Port field blank. If you want to use all the ports, you
can leave the port range empty.
Enabled or Disabled
Click Enabled to apply the filter policy or click Disabled to enter an inactive filter policy
(You can reactivate the policy later.)
Select the protocol type to allow or deny certain types of IP addresses.
Schedule
Select Always, or choose From and enter the time period during which the IP filter policy
will be in effect.
To Next Page
Loading...
Need help?
General
