56
Using the Configuration Menu
Advanced > Firewall Continued
Schedule
Select Always, or choose From and enter the time period during which the virtual ser-
vice will be available.
IP Address
Enter in the IP address range of the computers that you want the policy to apply to. If it
is only a single computer that you want the policy applied to, then enter the IP address of
that computer in the Start Source IP and leave the End Source IP blank.
Port Range
Enter in the port range of the TCP/UDP ports that you want the policy to apply to. If it is
only a single port that you want the policy applied to, then enter the port number in the
Start Port field and leave the End Port field blank. If you want to use all the ports, you
can leave the port range empty.
Protocol
Select one of the following protocols: TCP, UDP, or ICMP.
To Next Page
Loading...
Need help?
General
