D-Link DIR-514 - Manual Wireless Network Setup

21D-Link DIR-514 User Manual
Section 3 - Conguration
Manual Wireless Network Setup
Check the box to enable the wireless function. If you do not want to
use wireless, uncheck the box to disable all the wireless functions.
Service Set Identier (SSID) is the name of your wireless network.
Create a name using up to 32 characters. The SSID is case-sensitive.
Select one of the following:
802.11g Only - Select if all of your wireless clients are 802.11g.
802.11n Only - Select only if all of your wireless clients are 802.11n.
Mixed 802.11n and 802.11g - Select if you are using a mix of 802.11n
and 11g wireless clients.
The Auto Channel Scan setting can be selected to allow the DIR-514
to choose the channel with the least amount of interference.
Indicates the channel setting for the DIR-514. By default the channel
is set to 6. The Channel can be changed to t the channel setting for
an existing wireless network or to customize the wireless network.
If you enable Auto Channel Scan, this option will be greyed out.
Select the transmission rate. It is strongly suggested to select
Best(Auto) for best performance.
Select the Channel Width:
Auto 20/40 - This is the default setting. Select if you are using both
802.11n and non-802.11n wireless devices.
20MHz - Select if you are not using any 802.11n wireless clients.
40MHz - Select if using only 802.11n wireless clients.
Select Invisible if you do not want the SSID of your wireless network
to be broadcasted by the DIR-514. If Invisible is selected, the SSID of
the DIR-514 will not be seen
Enable Wireless:
Wireless
Network Name:
802.11 Mode:
Enable Auto
Channel Scan:
Wireless
Channel:
Transmission
Rate:
Channel Width:
Visibility Status: