D-Link DIR-514 - Network Settings

27D-Link DIR-514 User Manual
Section 3 - Conguration
This section will allow you to change the local network settings of the router and to congure the DHCP settings. The DIR-514 has a built-in DHCP
(Dynamic Host Control Protocol) server. The DHCP server assigns IP addresses to devices on the network that request them. By default, the DHCP
server is enabled on the device. The DHCP address pool contains a range of IP addresses, which is automatically assigned to the clients on the
network. After modifying any settings, click Save Settings to save your changes.
Network Settings
Enter the IP address you want to use for the router. The default IP
address is 192.168.0.1.
If you change the IP address, you will need to enter the new IP address
in your browser to get into the conguration utility.
Enter the Subnet Mask of the router. The default subnet mask is
255.255.255.0.
Enter the local domain name (optional).
Select this box to enable the DHCP server on your router.
Enter the range of IPs for the DHCP server to use to assign IP addresses
to devices on your network.
Enter lease time for IP address assignments.
Enter the primary/secondary DNS IP Address that will be assigned
to DHCP clients.
Enter the primary/secondary WINS IP Address that will be assigned
to DHCP clients.
Router IP
Address:
Default Subnet
Mask:
Local Domain
Name:
Enable DHCP
Server:
DHCP IP Address
Range:
DHCP Lease Time:
DNS IP Addresses:
WINS IP
Addresses: