D-Link DIR-514 - Inbound Filter

41D-Link DIR-514 User Manual
Section 3 - Conguration
Select this box to enable inbound ltering.
Select a schedule to use and copy to the specied rule ID when you
click Copy to. You may select Always On or use a specic schedule
that you have dened. To create and edit schedules, please refer to
“Schedules” on page 54.
This identies the rule.
Specify the local IP address and then specify the port after the colon.
Specify the remote IP address and then the port after the colon.
Check the box to enable the specied rule.
Specify the schedule rule number. Click on the Add New Rule button
to create a new schedule rule. To create and edit schedules, please
refer to “Schedules” on page 54.
Go back to the previous lter page.
Advance to the next lter page.
Inbound Filter
Inbound Filter:
Use Schedule
Rule:
ID:
Source IP : Ports:
Destination IP :
Ports:
Enable:
Schedule Rule #:
Previous Page:
Next Page:
Inbound Filter enables you to control what packets are allowed to come in to your network from the Internet. The inbound lter only applies to
packets that are destined for Virtual Servers or DMZ hosts. After modifying any settings, click Save Settings to save your changes.