D-Link DIR-615/T - Configuration; Manual Wireless Network Setup

23D-Link DIR-615 User Manual
Section 3 - Conguration
Check the box to enable the wireless function. If you do not want to use
wireless, uncheck the box to disable all wireless functions. Click Add
New to create your own time schedule to enable the wireless function.
Service Set Identifier (SSID) is the name of your wireless network. Create
a name using up to 32 characters. The SSID is case-sensitive.
Select one of the following:
802.11b Only - Select if all of your wireless clients are 802.11b.
802.11g Only - Select if all of your wireless clients are 802.11g.
802.11n Only - Select only if all of your wireless clients are 802.11n.
Mixed 802.11g and 802.11b - Select if you are using both 802.11b
and 802.11g wireless clients.
Mixed 802.11n and 802.11g - Select if you are using a mix of 802.11n
and 802.11g wireless clients.
Mixed 802.11n, 802.11b, and 802.11g - Select if you are using a mix
of 802.11n, 11g, and 11b wireless clients.
The Auto Channel Scan setting can be selected to allow the DIR-615
to choose the channel with the least amount of interference.
Indicates the channel setting for the DIR-615. By default the channel
is set to 6. The channel can be changed to fit the channel setting for
an existing wireless network or to customize the wireless network. If
you enable Auto Channel Scan, this option will be greyed out.
Select the transmission rate. It is strongly suggested to select Best
(Auto) for best performance.
Select the channel width:
Auto 20/40 - Select if you are using both 802.11n and non-802.11n
wireless devices.
20MHz - Select if you are not using any 802.11n wireless clients. This
is the default setting.
Manual Wireless Network Setup
Enable Wireless:
Wireless
Network Name:
802.11 Mode:
Enable Auto
Channel Scan:
Wireless
Channel:
Transmission
Rate:
Channel Width: