D-Link DIR-615/T - Administrator Settings

55D-Link DIR-615 User Manual
Section 3 - Conguration
Enter a new password for the administrator login name. The
administrator can make changes to all settings.
Enter a name for the DIR-615 router.
Enables a challenge-response test to require users to type letters or
numbers from a distorted image displayed on the screen to prevent
online hackers and unauthorized users from using automated
methods to gain access to your router’s network settings.
Check to enable HTTPS to connect to the router securely.
Remote management allows the DIR-615 to be configured from
the Internet via a web browser. A username and password is still
required to access the web-based management interface. In general,
only a member of your network can browse the built-in web pages
to perform administrator tasks. This feature enables you to perform
administrator tasks from the remote (Internet) host.
The port number used to access the DIR-615.
Example: http://x.x.x.x:8080 where x.x.x.x is the Internet IP address
of the DIR-615 and 8080 is the port used for the web management
interface. If you have enabled HTTPS Server and checked Use
HTTPS, you must enter https:// as part of the URL to access the
router remotely.
Admin Password:
Gateway Name:
Enable Graphical
Authentication:
Enable HTTPS
Server:
Enable Remote
Management:
Remote Admin
Inbound Filter:
Administrator Settings
This page will allow you to change the Administrator and User passwords. You can also enable remote management. There are
two accounts that can access the management interface through the web browser. The accounts are admin and user. Admin
has read/write access while user has read-only access. User can only view the settings but cannot make any changes. Only the
Admin account has the ability to change both admin and user account passwords.