D-Link DIR-615+ - Page 74

70D-Link DIR-615+ User Manual
Section 4 - Conguration
IP Filter Create/Edit (cont)
Source IP Address
Set as: Choose Range or single IP address to enter a specic IP address or
ranges for the source lter. Choose Subnet to specify a subnet only.
Start/End IPv4/
IPv6 address:
If you have selected Range or single IP address, specify an IP address
range for the source lter. To specify a single address, use only the
Start IPv4/IPv6 address eld and leave the End IPv4/IPv6 address
eld blank.
Subnet IPv4/IPv6
address:
If you have selected Subnet, enter the source subnet to lter.
Ports
Destination port: Specify the destination port or ports to which the lter will apply.
Specify multiple ports by separating them with commas. Specify port
ranges by separating the beginning and end of the range with a colon.
Set source port
manually:
Toggle this switch to specify source ports to which the lter will apply.
Source port: If Set source port manually has been enabled, specify the source
port to which the lter will apply. Specify multiple ports by separating
them with commas. Specify port ranges by separating the beginning
and end of the range with a colon.
Click Apply when you are done.