9D-Link DIR-840 User Manual
Section 2 - Installation
Step 1. Align the attachment plate to your preferred position, and mark the hole positions on the wall, preferably
after locating studs in the wall.
Step 2. Where studs cannot be found, make holes in the wall and insert the provided screw anchors. Check that the
screw anchors are securely in place.
Step 3. Securely screw down the attachment plate on the wall.
The wall-mount kit includes the following items:
- Two 2 cm screws
- Two screw anchors
- One attachment plate
Wall-Mount Kit Installation
Step 4. Hang the router on the wall by sliding the tops of the screws through the holes on the bottom of the router
and then slide to lock into position. Conrm the the router is rmly in place.
DIR-840
Wall mount hole Wall mount hole
To Next Page
Loading...
