D-Link DIR-840 - Pptp

25D-Link DIR-840 User Manual
Section 3 - Setup
Select PPTP from the drop-down menu.
Select Static IP if your ISP assigned you the IP address,
subnet mask, gateway, and DNS server addresses. In most
cases, select Dynamic IP.
Enter the IP address for your PPTP connection.
Enter your PPTP subnet mask.
Enter the gateway IP address for your PPTP connection.
Enter the server IP address for your PPTP connection.
Enter your PPTP user name.
Enter your PPTP password and then retype the password
in the next box.
Select either Always-on, On-Demand, or Manual.
Enter a maximum idle time during which the Internet
connection is maintained during inactivity. To disable this
feature, enable Auto-reconnect.
Enter the primary and secondary DNS server addresses
(Static PPTP only).
My Internet
Connection Is:
Address Mode:
PPTP IP Address:
PPTP Subnet Mask:
PPTP Gateway IP
Address:
PPTP Server IP
Address:
User Name:
Password:
Reconnect Mode:
Maximum Idle
Time:
DNS Addresses:
PPTP
Choose PPTP if your ISP uses a PPTP connection. Your ISP will provide you with a username and password.