D-Link DIR-840 - L2 Tp

27D-Link DIR-840 User Manual
Section 3 - Setup
Select L2TP from the drop-down menu.
Select Static IP if your ISP assigned you the IP address,
subnet mask, gateway, and DNS server addresses. In most
cases, select Dynamic IP.
Enter the IP address for your L2TP connection.
Enter your L2TP subnet mask.
Enter the gateway IP address for your L2TP connection.
Enter the server IP address for your L2TP connection.
Enter your L2TP user name.
Enter your L2TP password and then retype the password in
the next box.
Select either Always-on, On-Demand, or Manual.
Enter a maximum idle time during which the Internet
connection is maintained during inactivity. To disable this
feature, enable Auto-reconnect.
Enter the primary and secondary DNS server addresses
(Static L2TP only).
My Internet
Connection Is:
Address Mode:
L2TP IP Address:
L2TP Subnet Mask:
L2TP Gateway IP
Address:
L2TP Server IP
Address:
User Name:
Password:
Reconnect Mode:
Maximum Idle
Time:
DNS Addresses:
L2TP
Choose L2TP if your ISP uses a L2TP connection. Your ISP will provide you with a username and password.