D-Link DIR-840 - Ipsec Settings

45D-Link DIR-840 User Manual
Section 3 - Setup
Check this box to enable IPSec.
Enter a name for your VPN tunnel.
Enter the local (LAN) subnet and mask.
(ex. 192.168.0.0/24)
Select if you will be connecting as a remote user or on a site
to site basis.
Enter the remote subnet and mask.
Enter the key for authentication.
If you choose to enable XAUTH you need to choose between
Server mode with an Authetication database, or Client
mode with a user name and password.
Enter the local identication for how you appear on the
network VPN when connected locally.
Enter the local identication for how you appear on the
network VPN when connected remotely.
Enabled:
Name:
Local Subnet/
Netmask:
Remote IP:
Remote Subnet/
Netmask:
Authentication
Pre-Shared Key:
Authentication
XAUTH:
Local ID:
Remote ID:
IPSec Settings
The DIR-840 supports IPSec as the Server Endpoint. IPSec (Internet Protocol Security) protocols can provide IP security at the network layer.