D-Link DIR-840 - Pppoe

52D-Link DIR-840 User Manual
Section 3 - Setup
PPPoE
Select PPPoE from the drop-down menu.
Enter the PPPoE account settings supplied by your
Internet provider (ISP).
Enter your PPPoE user name.
Enter your PPPoE password and then retype the
password in the next box.
Enter the ISP Service Name (optional).
Maximum Transmission Unit - you may need to
change the MTU for optimal performance with your
specic ISP. 1492 is the default MTU.
Select either Obtain DNS server address
automatically or Use the following DNS Address.
Enter the primary and secondary DNS server
addresses.
Check to enable DHCP-PD.
Enter the LAN (local) IPv6 address for the router.
Displays the router’s LAN Link-Local Address.
Check to enable the Autoconguration feature.
Select Stateful or Stateless autoconguration.
My IPv6 Connection:
PPPoE:
User Name:
Password:
Service Name:
MTU:
IPv6 DNS Settings:
Primary/Secondary DNS
Address:
Enable DHCP-PD
LAN IPv6 Address:
LAN Link-Local Address:
Enable Autoconguration:
Autoconguration Type: