D-Link DIR-840 - Ipv6 Firewall

73D-Link DIR-840 User Manual
Section 4 - Advanced
IPv6 Firewall
The IPv6 Firewall feature allows you to congure which kind of IPv6 trac is allowed to pass through the device. The IPv6
Firewall functions in a similar way to the IP Filters feature. You can enable or disable each custom rule by checking the respective
box on the left-hand side.
Select an action from the drop-down menu.
Enter a name to identify the IPv6 rewall rule.
Use the drop-down menu to select the time schedule that
the IPv6 Firewall Rule will be enabled on. The schedule may
be set to Always, which will allow the particular service to
always be enabled. You can create your own times in the
Maintenance > Schedules section.
Use the drop-down menu to specify the source and
destination interface that connects to the source IPv6
addresses of the rewall rule.
Enter the source and destination IPv6 address range in the
adjacent IP Address Range eld.
Use the Destination drop-down menu to specify the
interface that connects to the destination IP addresses of
the rewall rule.
Select the protocol of the rewall port (All, TCP, UDP, or
ICMP). Enter the rst port of the range that will be used for
the rewall rule in the rst box and enter the last port in the
eld in the second box.
Congure IPv6
Filtering:
Name:
Schedule:
Interface:
IP Address:
Destination:
Protocol: