47D-Link DIR-840 User Manual
Section 3 - Setup
PPTP/L2TP Settings
This page allows you to set up a VPN using either PPTP or L2TP.
Check this box to enable PPTP/L2TP settings.
Enter a name for your VPN.
Select PPTP or L2TP.
Enter the IP address of the VPN server.
Enter the remote IP range in the boxes.
Choose PAP, CHAP, or MSCHAP v2 for your authentication.
Choose either RC4, None, 40 bit, or 128 bit to determine
the strength level of your authentication.
If you wish to use extended authentication, choose a group
from the drop-down menu.
PPTP/L2TP:
Name:
Connection Type:
VPN Server IP:
Remote IP Range:
Authentication
Protocol:
MPPE Encryption
Mode:
Extended
Authentication:
To Next Page
Loading...
