46D-Link DIR-840 User Manual
Section 3 - Setup
Choose if you want to use a main or aggressive mode.
Enable or Disable the NAT-T option.
Enable or Disable Keep Alive protocols.
Choose whether or not to detect dead peers, then set the
amount of time in seconds before disconnect of dead peers.
You can also set a delay time in second before release.
Enable or Disable the DH Group option using the drop-
down menu.
Use this area to Enable IKE Proposals. Then determine
encryption and authentication types from the drop-down
menus.
Enter the amount of time in seconds that the Phase 1 keys
should last.
Phase1 Mode:
NAT-T Enable:
Keep Alive:
DPD:
DH Group:
IKE Proposal
Settings:
IKE Lifetime:
Choose if you want to use Perfect Forward Secrecy. PFS is
an additional security protocol.
Choose a PFS DH Group from the drop-down menu.
Use this area to choose the encryption and authentication
methods for IPSec proposals by choosing from the drop-
down menus.
Enter the amount of time in seconds that the Phase 2 keys
should last.
PFS Enable:
PFS DH Group:
IPSEC Proposal
List:
IPSec Lifetime:
To Next Page
Loading...
