25D-Link DNR-322L User Manual
Section 3 - Installation
Power and Device Selection
First, connect the power adapter to the power receptor on the back of the
NVR. Press the power button located under the faceplate LEDs to turn on
the NVR. Click Next on the Setup Wizard to continue.
Select your device from the device selection area. A confirmation window
will appear asking you to check if the device’s Power LED is solid. If it is
solid, select Yes in the confirmation window. Otherwise select No. If the
connection is good, then check that the hard drives are installed correctly
and have no other issues. Click Next to continue.
Note: When you select your device from the list, it will cause the LEDs to
blink to confirm the device selection.
Note: All configured NVRs are shown with their names in orange, while all
NVRs not configured are in blue.
To Next Page
Loading...
