D-Link DSL-2730E - Port Triggering

DSL-2730E User Manual
Field Description
Services Allowed
You can choose the following services from WAN:
Web, Telnet, SSH, TFTP, SNMP and PING. You
can also choose all the services.
Add
After setting the parameters, click it to add an entry
to the Current ACL Table.
Reset
Click it to refresh this page.
3.3.2.2 Access Control List IPv6
Choose Advanced > Access Control List > Access Control List IPv6. The
page shown in the following figure appears. For configuration method, refer to
3.3.2.1 Access Control List.
3.3.3 Port Triggering
Choose Advanced > Port Triggering. The page shown in the following figure
appears. Port Triggering is a special form of Port Forwarding in which it requires
an outgoing connection before allowing incoming connections on a single or
multiple ports. Port Triggering is mostly used when your computer is behind a
NAT router. It gives more flexibility than static port forwarding because you don't
need to set it up for a specific computer.
46