D-Link DXS-1210-16TC - Debug Commands

DXS-1210 Series Smart Managed Switch CLI Reference Guide
97
11. Debug Commands
11-1 debug show tech-support
This command is used to display the information required by technical support personnel.
debug show tech-support
Parameters
None.
Default
None.
Command Mode
Privileged EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 15.
Usage Guideline
Use this command to display technical support information. The technical support information is used
to collect the Switch’s information needed by the engineers to troubleshoot or analyze a problem.
Example
This example shows how to display technical support information of all the modules.
Switch# debug show tech-support
#---------------------------------------------------------------------
# DXS-1210-12SC 10GbE Smart Managed Switch
# Technical Support Information
#
# Firmware: V1.15.005
# Copyright(C) 2017 D-Link Corporation. All rights reserved.
#---------------------------------------------------------------------
******************** Basic System Information ********************
Boot Time :0 days, 3 hrs, 21 min, 35 secs
RTC Time :01/01/2017 03:21:34
Boot PROM Version :V1.00.006
Firmware Version :V1.15.005
Hardware Version :A2
MAC Address :00-99-22-88-11-66
Serial Number :QBDGS12102800
SNMP Status :Disabled
Safeguard Engine :Disabled
IGMP Snooping :Disabled
Scheduled Port-shutdown Power Saving :Disabled
Scheduled Hibernation Power Saving :Disabled
Scheduled Dim-LED Power Saving :Disabled
Administrative Dim-LED :Disabled
Switch#