D-Link DXS-1210-16TC - Ethernet Ring Protection Switching (ERPS) Commands

DXS-1210 Series Smart Managed Switch CLI Reference Guide
125
18. Ethernet Ring Protection Switching (ERPS)
Commands
For more information, refer to Appendix E - ERPS Information.
18-1 description
This command is used to configure the description for Ethernet Ring Protection (ERP) instances.
description DESCRIPTION
no description DESCRIPTION
Parameters
None.
Default
None.
Command Mode
ERP Instance Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to configure the description for the ERP instances.
Example
This example shows how to configure the description for the ERP instances.
Switch#configure terminal
Switch(config)# erps instance 1
Switch(config-erp-instance)#description custom-description
Switch(config-erp-instance)#
18-2 ring
This command is used to create or modify an ITU-T G.8032 ERP physical ring and enter the ERP
configuration mode. Use the no form of this command to delete the specified ring.
ring RING-NAME
no ring RING -NAME
Parameters
RING-NAME
Specifies the name of the ERP ring with the maximum of 32
characters.
Default
None.
Command Mode