DXS-1210 Series Smart Managed Switch CLI Reference Guide
11
Switch#help
The switch CLI provides advanced help feature.
1. Help is available when you are ready to enter a command
argument (e.g. 'show ?') and want to know each possible
available options.
2. Help is provided when an abbreviated argument is entered
and you want to know what arguments match the input(e.g. 'show ve?'.).
If nothing matches, the help list will be empty and you must backup
until entering a '?' shows the available options.
3. For completing a partial command name could enter the abbreviated
command name immediately followed by a <Tab> key.
Note:
Since the character '?' is used for help purpose, to enter
the character '?' in a string argument, press ctrl+v immediately
followed by the character '?'.
Switch#
The following example shows how to use the word help to display all the Privileged EXEC Mode
commands that begin with the letters “re”. The letters entered before the question mark (?) are
reprinted on the next command line to allow the user to continue entering the command.
Switch#re?
reboot reset
Switch#re
The following example shows how to use the command syntax help to display the next argument of
a partially complete IP access-list standard command. The characters entered before the question
mark (?) is reprinted on the next command line to allow the user to continue entering the command.
Switch(config)#ip access-list standard ?
<1-1999> Standard IP access-list number
<cr>
Switch(config)#ip access-list standard
2-2 configure terminal
This command is used to enter the Global Configuration Mode.
configure terminal
Parameters
None.
Default
None
Command Mode
User EXEC Mode or Privilege EXEC Mode.
Command Default Level
To Next Page
Loading...
Need help?
General