DXS-1210 Series Smart Managed Switch CLI Reference Guide
148
Parameters
interface
Specifies a static multicast router port.
forbidden interface
Specifies a port that cannot be multicast router port.
INTERFACE-ID
(Optional) Specifies an interface or an interface list. The interface can
be a physical interface or a port-channel.
,
(Optional)Specifies a series of interfaces, or a separate a range of
interfaces from a previous range. No space is allowed before and after
the comma.
-
(Optional)Specifies a range of interfaces. No space is allowed before
and after the hyphen.
Default
No IGMP snooping multicast router port is configured.
Auto-learning is enabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is only available for VLAN interface configuration. To specify a multicast router port,
the valid interface can be a physical port or a port-channel. The specified multicast router port must be
member port of the configured VLAN. A multicast router port can be either dynamic learned or
statically configured. With the dynamic learning, the IGMP snooping entity will learn IGMP, PIM, or
DVMRP packet to identify a multicast router port.
Example
This example shows how to add an IGMP snooping static multicast router port for VLAN 1.
Switch# configure terminal
Switch(config)#vlan 1
Switch(config-vlan)# ip igmp snooping mrouter interface eth 1/0/1
Switch(config-vlan)#
20-6 ip igmp snooping querier
This command is used to enable the capability of the entity as an IGMP querier. Use the no form of
this command to disable the querier function.
ip igmp snooping querier
no ip igmp snooping querier
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Interface Configuration Mode.
Command Default Level
To Next Page
Loading...
Need help?
General