DXS-1210 Series Smart Managed Switch CLI Reference Guide
213
28. MLD Snooping Commands
28-1 clear ipv6 mld snooping statistics
This command is used to clear the statistic counter of the Switch.
clear ipv6 mld snooping statistics {all | vlan VLAN-ID}
Parameters
all
Specifies to clear IPv6 MLD snooping statistics for all VLANs and all
ports.
vlan VLAN-ID
Specifies the VLAN used. If no VLAN is specified, statistics for all
VLANs are cleared.
Default
None.
Command Mode
Privilege EXEC Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to clear the statistic counter of the Switch.
Example
This example shows how to clear all MLD snooping statistics.
Switch# clear ipv6 mld snooping statistics all
Switch#
28-2 ipv6 mld snooping
This command is used to enable or disable MLD snooping.
ipv6 mld snooping
no ipv6 mld snooping
Parameters
None.
Default
MLD snooping is disabled on all VLAN interfaces.
The MLD snooping global state is disabled by default.
Command Mode
Interface Configuration Mode.
Global Configuration Mode.
Command Default Level
To Next Page
Loading...
Need help?
General