DXS-1210 Series Smart Managed Switch CLI Reference Guide
163
Switch#show interfaces eth1/0/1
Eth1/0/1 is enabled, link status is up
Interface type: 1000BASE-T
Interface description:
MAC Address: 00-01-02-03-04-01
Auto-duplex, auto-speed, auto-mdix
Send flow-control: off, receive flow-control: off
Send flow-control oper: off, receive flow-control oper: off
Full-duplex, 1Gb/s
Maximum transmit unit: 1536 bytes
Rx rate: 0 bytes/sec, TX rate: 0 bytes/sec
RX bytes: 116316, TX bytes: 132495
RX rate: 0 packets/sec, TX rate: 0 packets/sec
RX packets: 1213, TX packets: 365
RX multicast: 774, RX broadcast: 439
RX CRC error: 0, RX undersize: 0
RX oversize: 0, RX fragment: 0
RX jabber: 0, RX dropped Pkts: 1212
RX MTU exceeded: 0, TX excessive deferral: 0
TX single collision: 0, TX excessive collision: 0
TX late collision: 0
Switch#
21-7 show interfaces counters
This command is used to display counters on specified interfaces.
show interfaces [INTERFACE-ID [,|-]] counters [errors]
Parameters
errors
(Optional) Specifies to display the error counters.
INTERFACE-ID
(Optional) Specifies that the interface can be a physical port. If no
interface is specified, the counters on all interfaces will be displayed.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command allows the user to display switch port statistics counters.
Example
This example shows how to display switch port counters on ports 1 to 8.
To Next Page
Loading...
Need help?
General