D-Link DXS-1210-16TC - Simple Network Management Protocol (SNMP) Commands

DXS-1210 Series Smart Managed Switch CLI Reference Guide
289
38. Simple Network Management Protocol
(SNMP) Commands
38-1 show snmp-server
This command is used to display the SNMP server’s global state settings and trap related settings.
show snmp-server [traps]
Parameters
traps
(Optional) Specifies to display trap related settings.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use the show snmp-server command to display the SNMP server global state settings.
Use the show snmp-server traps command to display trap related settings.
Example
This example shows how to display the SNMP server configuration.
Switch# show snmp-server
SNMP Server : Enabled
Name : SiteA-Switch
Location : HQ 15F
Contact : MIS Department II
SNMP UDP Port: 50000
SNMP Response Broadcast Request: Enabled
Trap Source Interface : vlan1
Switch#
This example shows how to display trap related settings.