D-Link DXS-1210-16TC - Show Ip Igmp Snooping Mrouter

DXS-1210 Series Smart Managed Switch CLI Reference Guide
154
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display IGMP snooping group information.
Example
This example shows how to display IGMP snooping group information.
Switch# show ip igmp snooping groups
IGMP Snooping Connected Group Membership:
VLAN ID Group address Source address Exp(sec) Interface
------- --------------- --------------- -------- ---------
1 239.255.255.250 * 382 2/0/7
Total Entries: 1
Switch#
20-14 show ip igmp snooping mrouter
This command is used to display IGMP snooping router port information learned and configured on
the Switch.
show ip igmp snooping mrouter [vlan VLAN-ID]
Parameters
vlan VLAN-ID
(Optional) Specifies the VLAN. If no VLAN is specified, IGMP snooping
information on all VLANs will be displayed of which IGMP snooping is
enabled.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display dynamically learned or manually configured multicast router interfaces.
Example
This example shows how to display IGMP snooping router port information.