DXS-1210 Series Smart Managed Switch CLI Reference Guide
160
Switch# configure terminal
Switch(config)# interface range ethernet 1/0/2-5,1/0/7
Switch(config-if-range)#
This example shows how to enter combo sfp port interface configuration mode for the
range of ports 1/0/11 to 1/0/12
Switch# configure terminal
Switch(config)# interface combo fiber range ethernet 1/0/11-12
Switch(config-if-combo-range)#
21-5 show counters
This command is used to display interface information.
show counters [interface INTERFACE-ID]
Parameters
INTERFACE-ID
Specifies that the interface can be a physical port. If no interface is
specified, counters of all interfaces will be displayed.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display the statistic counters for an interface.
Example
This example shows how to display the counters for interface eth1/0/1.
To Next Page
Loading...
