D-Link DXS-1210-16TC - Page 169

DXS-1210 Series Smart Managed Switch CLI Reference Guide
166
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command displaysthe Switch’s port connection status.
Example
This example shows how to display the Switch’s port connection status.
Switch# show interfaces ethernet 1/0/1-8 status
Port Status MAC Address VLAN Duplex Speed
Type
----------- -------------- ------------------ ----- ---------- -----------
---------
eth1/0/1 Not-Connected 00-00-04-01-02-02 1 Auto Auto
10GBASE-T
eth1/0/2 Not-Connected 00-00-04-01-02-03 1 Auto Auto
10GBASE-T
eth1/0/3 Not-Connected 00-00-04-01-02-04 1 Auto Auto
10GBASE-T
eth1/0/4 Not-Connected 00-00-04-01-02-05 1 Auto Auto
10GBASE-T
eth1/0/5 Connected 00-00-04-01-02-06 1 Auto-Full Auto-1000M
10GBASE-T
eth1/0/6 Not-Connected 00-00-04-01-02-07 1 Auto Auto
10GBASE-T
eth1/0/7 Not-Connected 00-00-04-01-02-08 1 Auto Auto
10GBASE-T
eth1/0/8 Not-Connected 00-00-04-01-02-09 1 Auto Auto
10GBASE-T
21-9 shutdown
This command is used to disable an interface. Use the no form of this command to enable an
interface.
shutdown
no shutdown
Parameters
None.
Default
By default, this option is no shutdown.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline