D-Link DXS-1210-16TC - Page 253

DXS-1210 Series Smart Managed Switch CLI Reference Guide
250
Switch# configure terminal
Switch(config)#port-security limit global 100
Switch(config)#
31-7 show port-security global-settings
This command is used to display port security global settings.
show port-security global-settings
Parameters
None
Default
None.
Command Mode
EXEC Mode
Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display port security global settings.
Example
This example shows how to display port security global settings.
Switch# show port-security global-settings
Trap State : Disabled
Trap Rate : 0
System Maximum Address : No Limit
Switch#
31-8 show snmp-server traps port-security
This command is used to display port security traps is enabled or not.
show snmp-server traps port-security
Parameters
None
Default
None.
Command Mode
EXEC Mode
Any Configuration Mode.