D-Link DXS-1210-16TC - Page 321

DXS-1210 Series Smart Managed Switch CLI Reference Guide
318
Default
By default, this value is 6.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command specifies the number of hold BPDUs to transmit. The transmission of BPDUs on a port
is controlled by a counter. The counter is incremented on every BPDU transmission and decremented
once a second. The transmissions are paused for one second if the counter reaches the transmit hold
count.
Example
This example shows how to configure the transmitholdcount value to 5.
Switch# configure terminal
Switch(config)#spanning-tree tx-hold-count 5
Switch(config)#
39-17 spanning-tree forward-bpdu
This command is used to enable the forwarding of the spanningtree BPDU. Use the no form of this
command to disable the forwarding of the spanningtree BPDU.
spanning-tree forward-bpdu
no spanning-tree forward-bpdu
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
If enabled, the received STP BPDU will be forwarded to all VLAN member ports in the untagged form.
The command does not take effect if the Layer 2 protocol tunnel is enabled for STP.
Example
This example shows how to enable the forwarding of STP BPDUs.
Switch# configure terminal
Switch(config)#interface eth 1/0/1
Switch(config-if)# spanning-tree forward-bpdu
Switch(config-if)#