D-Link DXS-1210-16TC - Page 341

DXS-1210 Series Smart Managed Switch CLI Reference Guide
338
Switch#show running-config
#------------------------------------------------------------------------
# DXS-1210-12SC 10GbE Smart Managed Switch Configuration
#
# Firmware: Build V1.15.005
# Copyright(C) 2017 D-Link Corporation. All rights reserved.
#------------------------------------------------------------------------
command-start
# Basic
# LACP
configure terminal
lacp system-priority 32768
port-channel load-balance src-mac
interface range ethernet 1/0/1-2
channel-group 1 mode on
exit
interface ethernet 1/0/1
lacp port-priority 32768
lacp timeout short
exit
interface ethernet 1/0/2
lacp port-priority 32768
lacp timeout short
CTRL+C ESC q Quit SPACE n Next PageENTER Next Entry a All
43-6 show startup-config
This command is used to display the content of the startup configuration file.
show startup-config
Parameters
None.
Default
None.
Command Mode
Privileged EXEC Mode.
Command Default Level
Level: 15.
Usage Guideline
This command displays the configuration settings that the system will be initialized with.
Example
This example shows how to display the content of the startup configuration file.