D-Link DXS-1210-16TC - Page 64

DXS-1210 Series Smart Managed Switch CLI Reference Guide
61
Switch# show terminal
Terminal Settings:
Length: 25 lines
Width: 80 columns
Default Length: 25 lines
Default Width: 80 columns
Baud rate: 115200 bps
Switch#
5-12 show ip telnet server
This command is used to obtain information about the Telnet server status.Use this command in any
EXEC mode or any configuration mode.
show ip telnet server
Parameters
None.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display information about the Telnet server status.
Example
This example shows how to display information about the Telnet server status.
Switch# show ip telnet server
Server State: Enabled
Switch#
5-13 show ip http server
This command is used to obtain information about the http server status.Use this command in EXEC
mode or any configuration mode.
show ip http server
Parameters
None.
Default