D-Link DXS-1210-16TC - Page 68

DXS-1210 Series Smart Managed Switch CLI Reference Guide
65
Example
This example shows how to adjust the current session terminal width to 120 characters.
Switch# show terminal
Terminal Settings:
Length: 25 lines
Width: 80 columns
Default Length: 25 lines
Default Width: 80 columns
Baud rate: 115200 bps
Switch# terminal width 120
Switch# show terminal
Terminal Settings:
Length: 25 lines
Width: 120 columns
Default Length: 25 lines
Default Width: 80 columns
Baud rate: 115200 bps
Switch #
5-18 username
This command is used to create a user account. Use the no form of this command to delete the user
account.
username NAME [privilege LEVEL] [nopassword | password [0 | 7 | 15] PASSWORD]
no username [NAME]
Parameters
NAME
Specifies the user name with a maximum of 32 characters.
privilege LEVEL
(Optional) Specifies the privilege level for each user. The privilege
level must be between 1 and 15.
nopassword
(Optional) Specifies that there will be no password associated with this
account.
password
(Optional) Specifies the password for the user.
0
(Optional) Specifies the password in clear, plain text. The password
length is between 1 and 32 characters and can contain embedded
spaces. It is case-sensitive. If the password syntax cannot be
specified, the syntax remains plaintext.
7
(Optional) Specifies the encrypted password based on SHA-1. The
password length is fixed at 35 bytes. It is case-sensitive. The password
is encrypted. If the password syntax is not specified, the syntax is plain
text.
15
(Optional) Specifies the encrypted password based on MD5. The
password length is fixed at 31 bytes. It is case-sensitive. The password
is encrypted. If the password syntax is not specified, the syntax is plain
text.
PASSWORD
(Optional) Specifies the password string based on the type.