DXS-1210 Series Smart Managed Switch CLI Reference Guide
88
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The IPv6 address can directly be specified by the user or configured based on a general prefix. The
general prefix can be acquired by the DHCPv6 client. The general prefix does not need to exist before
it can be used in the ipv6 address command. The IPv6 address will not be configured until the
general prefix is acquired. The configured IPv6 address will be removed when the general prefix is
timeout or removed. The general prefix IPv6 address is formed by the general prefix in the leading
part of bits and the sub-bits excluding the general prefix part in the remaining part of bits.
An interface can have multiple IPv6 addresses assigned using a variety of mechanisms, including
manual configuration, stateless address configuration, and stateful address configuration. However,
within the same prefix, only one IPv6 address can be configured.
When the IPv6 address is configured on an interface, IPv6 processing is enabled for the interface.
The prefix of the configured IPv6 address will automatically be advertised as prefix in the RA
messages transmitted on the interface.
Example
This example shows how to configure an IPv6 address.
Switch# configure terminal
Switch(config)#interface vlan 2
Switch(config-if)# ipv6 address 3ffe:22:33:44::55/64
This example shows how to remove an IPv6 address.
Switch# configure terminal
Switch(config)# interface vlan 2
Switch(config-if)# no ipv6 address 3ffe:22:3:44::55/64
9-3 ipv6 address dhcp
This command is used to configure an interface using DHCPv6 to get an IPv6 address. Use the no
form of this command to disable the using of DHCPv6 to get an IPv6 address.
ipv6 address dhcp [rapid-commit]
no ipv6 address dhcp
Parameters
rapid-commit
Specifies to proceed with two-message exchange for address
delegation. The rapid-commit option will be filled in the Solicit message
to request two messages handshake.
Default
None.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
To Next Page
Loading...
Need help?
General