11
Once you have connected your TV to an antenna or cable system, plugged the TV in, and put
batteries in the remote, you are ready to use the TV. The first thing you should do is to program
your TV so it memorizes all of available channels.
Your TV's memory determines the channels that are available using the WCHV but-
tons. If a channel is not in memory, you can tune to it with the number buttons, but not
with the WCHV buttons. Follow these steps to program your TV's memory:
With the TV on, press the MENU button. Then press
the CVOLB buttons until “Set-up” menu will be dis-
played.
1
To turn your TV on, press the POWER button on the remote
control. You can also use the POWER button on the front panel.
Make sure your TV is plugged in before you try to turn it on.
Operating Your TV
Turning Your TV On
Programming Your TV's Channel Memory
Use the WCHV buttons to select “Reception” item,
then use the CVOLB buttons to select ‘Air’ or
‘Cable’. If you connected an antenna to your TV,
select ‘Air’; If you connected a cable system, select
‘Cable’.
Use the WCHV buttons to select “Memorize Ch.”, then use the CVOLB buttons to
enter the “Memorize Ch.” process.
2
3
To Next Page
Loading...
