Wait 15 seconds, or press DISPLAY button or
MENU button to return to normal TV viewing.
Your TV's channel memory will not be affected
by a power outage. You will not need to re-pro-
gram the memory unless you change the type
of cable or antenna connected to your TV.
If you want to stop the “Memorize Ch.” process,
press the MENU button to return to Set-up menu.
You can change channels in three ways:
1
The WCHV buttons will take you through all
memorized channels, one by one. The WCHV
buttons will not access channels that have not
been programmed into the TV's memory. For
more information about programming channels
into memory, see the section “Programming your
TV's Channel Memory” on the previous page.
2
The number buttons (0-9) will take you to any
channel, even if it has not been memorized. To
change to a channel, enter its number; the TV
will tune to the new channel when you enter the
second digit of the channel.
3
The PREVIOUS button will take you instantly to
the last channel you were watching.
Changing Channels
1
To change the volume of the TV set, use the
CVOLB buttons on the remote controller or on
the front panel.
2
To quickly turn off the sound, press the MUTE
button on the remote. The ‘ ’ will appear on
screen. To return the volume to its previous level,
press MUTE again.
Changing the Volume
4
5
To Next Page
Loading...
